BEHRINGER UB1002FX MANUAL PDF

| | 0 Comments

User guide • Read online or download PDF • Behringer UBFX User Manual • Behringer Musical Instruments. 00 SMALL HALL 1 approx. s reverb decay. 50 SHORT DELAY 1. Like a short shattering. 01 SMALL HALL 2 approx. s reverb decay. 51 SHORT DELAY 2. EURORACK UBFX/UBFX User Manual. Table of Contents . The BEHRINGER EURORACK mixing console offers you premium-quality microphone.

Author: Zulkikora Moshakar
Country: Costa Rica
Language: English (Spanish)
Genre: Relationship
Published (Last): 21 September 2010
Pages: 72
PDF File Size: 17.11 Mb
ePub File Size: 18.15 Mb
ISBN: 388-1-57611-357-3
Downloads: 93167
Price: Free* [*Free Regsitration Required]
Uploader: Fegal

The safety and operating instructions should be retained for future reference.

Behringer Europack UB1202FX Owner’s Manual

Summing of signals to the aux sends for effects processing and monitor mix, distribution to one or several recording tracks, power amp scontrol room and 2-track outputs. Well, for over 30 years, my passion has been music and electronics.

Connectors of the main section can be connected. Power cords should be routed so that they are not likely to bfhringer walked on or pinched by items placed upon or against them, paying particular attention to cords and plugs, sockets, outlets and the point where they exit from the device. To correctly set the gains of the channels, first set the LEVEL controls of the input channels to their center positions 0 dB.

Please also note the instructions in chapter 2. After switching on, wait approx.

Suite Bothell, WAPhone: For example, the device should not be placed on a bed, sofa, rug, or similar surface that may block the ventilation openings, or used in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. Alternatively the line or tape output of a hi-fi amplifier with source selection switch could also be hooked up here, allowing you to easily listen to additional sources. This warranty is extended exclusively to the original buyer customer of retail dealer and is not transferable to anyone who may subsequently purchase this product.

  EL CAMINO DE LA PERFECCION WAYNE W DYER PDF

This does, however, give you the ability to use the channel EQ on the effects return signal if you wish. You can instead use these connectors as additional inputs, but any effects 2. Blown fuses must ,anual be replaced by fuses of the same type and rating.

Behringer Europack UBFX Owner’s Manual – Page 1 of 16 |

All controls, switches and connectors will be discussed in detail. For your own safety, you should never remove any ground connectors from electrical devices or power cables, amnual render them inoperative.

The return from the effects unit is then brought back into the console on the aux return connectors UB or normal channel inputs. The warranty regulations mentioned herein are applicable unless they constitute an infringement of national warranty law. The design work, the entire circuit diagram and PCB development, and even the mechanical concepts are my own work.

The device should be cleaned only as recommended by the manufacturer. All the safety and operation instructions should be read before the device is operated.

All inquiries must be accompanied by a description of the problem. This provides an easy way to monitor signals coming back from tape to ensure that they are recording correctly. The device should be situated away from heat sources such as radiators, heat registers, stoves, or other devices including amplifiers that produce heat.

By pressing ‘print’ button you will print only current page. This manual also for: The adapter complies with all applicable safety standards. Specifications and appearance may differ from those listed or illustrated.

  IC 74HC147 PDF

The equalizer of the mono input channels EQ The upper HI and the lower band LO are shelving filters that increase or decrease all frequencies above or below their cut-off frequency. Introduction They enable full utilization of the greatly extended dynamic range of your signal path is required e. The user should not attempt to service the device beyond that which is described in the operating instructions. Assignment switches of the main section Fig.

Behringer EURORACK UB1202FX User Manual

Always be careful to set appropriate volume levels. If a channel is operated in mono bbehringer the left line input, this control has the same function as the PAN control used in the mono channels. The stereo channels are designed to handle typical line level signals.

The console is connected to the mains via the supplied cable. I should also like to thank all bwhringer who, with their personal commitment and passion, have helped me realize this impressive series of mixing consoles. However, since ub10002fx FX send buses are both mono, a mono sum is first taken from the stereo input before it is sent to the FX bus.

CD player, tape deck, etc. No user serviceable parts inside; refer servicing to qualified personnel.

Behringer EURORACK UBFX User`s manual |

Page of 15 Go. Table of Contents Add to my manuals Add. This control should always be the LEVEL control determines the level of the channel signal in the main mix.

Enter text from picture: All bands provide boost or cut of up to 15 dB.